Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Bald Knob, AR

Haas Door Torsion Spring Replacement in Bald Knob, AR

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

Our Haas Door torsion spring replacement service in Bald Knob, AR comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Torsion springs replaced and wound correctly, with high-cycle upgrades available. Whether your Haas Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for Haas Door torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

Why this happens

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

Before the technician arrives

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Haas Door torsion spring replacement

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Typical Haas Door torsion spring replacement prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Haas Door services

Local Haas Door torsion spring replacement for Bald Knob, AR

Humidity in Arkansas puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Technicians serve all of Bald Knob (ZIP code 72010), plus Judsonia (4.9 mi), Searcy (10.3 mi), Augusta (11.6 mi) and Beebe (24.1 mi). Call (833) 435-8883 to book a visit in Bald Knob.

Haas Door Torsion Spring Replacement: frequently asked questions

How much does Haas Door torsion spring replacement cost in Bald Knob, AR?

Haas Door Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Haas Door torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Haas Door torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Haas Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Arkansas or Bald Knob requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Bald Knob, AR

Amarr Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$450

Ryobi Opener Circuit Board Replacement

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $175-$400

Haas Door Weather Seal Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $100-$300

Opener Gear & Sprocket Replacement

Stripped drive gears replaced so the motor moves the door again.

Typical $125-$275

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Haas Door Garage Door Installation

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $1,200-$4,500

Cornell Cookson Rolling Fire Door Inspection & Drop Testing

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $150-$500

Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Raynor Off-Track Garage Door Repair

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $175-$450

Genie Opener Circuit Board Replacement

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $175-$400

Belt Drive Opener Installation & Repair

Quiet belt-drive openers, ideal for garages under bedrooms.

Typical $400-$900

Northwest Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Bald Knob, AR now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote